The Mackwell PRIMIAN-1 S3CHE is an emergency inverter for use with T5 lamps with wattages between 18 and 36w. It is fitted with a 5 pole relays to swich all four lamp connections from ballast to inverter and switch of the power to the ballast during emergency lighting testing. The modules can therefore be safely connected to a circuting with an electronic HF ballast and provide complete isolation to the control gear. This inverter should be used with a 3 cell battery pack.

The Mackwell PRIMIAN-1 S4CHE is an emergency inverter for use with T5 lamps with wattages between 18 and 58w. It is fitted with a 5 pole relays to swich all four lamp connections from ballast to inverter and switch of the power to the ballast during emergency lighting testing. The modules can therefore be safely connected to a circuting with an electronic HF ballast and provide complete isolation to the control gear. This inverter should be used with a 4 cell battery pack.

The Mackwell PRIMIAN-1 S5CHE is an emergency inverter for use with T5 lamps with wattages between 18 and 70w. It is fitted with a 5 pole relays to swich all four lamp connections from ballast to inverter and switch of the power to the ballast during emergency lighting testing. The modules can therefore be safely connected to a circuting with an electronic HF ballast and provide complete isolation to the control gear. This inverter should be used with a 5 cell battery pack.

The Existalite XCU258.3F is an emergency combined ballast and inverter to run 2 x 58w T8 fluorescent tubes. These emergency combo units have an emergency duration of 3 hours and a recharge period of only 20 hours. They are supplied with IDC/Push -wire terminals and suited to automatic and manual assembly. The XCU258.3E should be used with a 4 cell emergency battery pack.

The Existalite XCU270.3G is an emergency combined ballast and inverter to run 2 x 70w T8 fluorescent tubes. These emergency combo units have an emergency duration of 3 hours and a recharge period of only 20 hours. They are supplied with IDC/Push -wire terminals and suited to automatic and manual assembly. The XCU270.3G should be used with a 5 cell emergency battery pack.

The Philips HID-PV Cx 2x35 35 /l CDM electronic ballast comes complete with strain relief and runs 2x35w metal halide lamps.this ballast is available as independent (/I) for independent use on a (false) ceiling, minimal lamp power spread, microprocessor controlled, lamp end of life detection, long lifetime of 40,000 hours, lamp life is increased by up to 30% for CDM lamps, silent operation without hum it is also RoHS compliant. This Philips HID-PV is usually used in accent and decorative lighting for shops and retail, public spaces, lobbies and offices. This unit is designed for optimum system performance with Philips MASTERcolour CDM lamps.

The Transtar K100E is a high frequency balalst to run 1 x 8ft 100w T12 fluorescent tube.

The Transtar K125E is a high frequency balalst to run 1 x 8ft 125w T12 fluorescent tube.

Mackwell 3x2 Cell Emergency Battery Stick. NiMH (Nickel Metal Hydride) 4AH Plate.

The Existalite XT.CB/50 is a 5 pole inverter suitable for use on 50 volt systems. It is ideally suited for individual local circuit failure monitoring via the connection of an unswitched supply. The XT.CB/50 has an integral five pole relay to disconnect the normal mains lighting ballast from the lamp when the mains supply is disconnected.

The Existalite XT.CB/110 is a 5 pole inverter suitable for use on 110 volt systems. It is ideally suited for individual local circuit failure monitoring via the connection of an unswitched supply. The XT.CB/110 has an integral five pole relay to disconnect the normal mains lighting ballast from the lamp when the mains supply is disconnected.

This is an Existalite CR.CB/110 continuously rated central battery inverter suitable for 110 Volt systems.

Venture HIT 250W/HOR/EURO/4K is a 250 watt Enclosed Rated Euro Metal Halide Tubular Venture lamp.This lamp has an average life of 10,000 hours and are supplied with a clear finish. This lamp has a giant screw cap and the colour is 4000k. Venture part number is 57712

250w Metal Halide Low Bay fitting c/w Liangfeng Ballast, the 250w high bay fitting has a powder coated body and aluminium reflector, this lamp requires a tubular metal halide lamp (not included).

This is an IP20 rated led round light kit, this kit has a satin chrome finish and emits a white light. This light is made from Die cast aluminium and comes complete with 3 x 1.2w led lamps.

Philips Master LED Spot PAR 30S. This LED PAR 30S lamp has an ES (E27) Cap and a 22 deg beam, it has an average lamp life of 45,000 hours and is colour 2700k, this 12w lamp is equivalent to a 75w halogen lamp.

The Existalite XHF21.3E is a combined emergency lighting unit designed to fit simply within contemporary luminaires. It can be used to run 1 x 16 or 21w 2D lamp. It has an emergency duration of 3 hours and a recharge period of only 20 hours. They come complete with a lampholder, LED indicator and NiCad battery. This gear tray only requires unswitched live, switched live, neutral and earth supply connections. It is supplied complete with screw terminals with cable protectors for mains connections.

A Toshiba 6.5w GX53 LED lamp with a 100 degree beam. This lamp has a colour temperature of 2700K and an average life of 40,000 hours.

A Toshiba 6.5w GX53 LED lamp with a 40 degree beam. This lamp has a colour temperature of 4000K and an average life of 40,000 hours.

A Toshiba 6.5w GX53 LED lamp with a 40 degree beam. This lamp has a colour temperature of 2700K and an average life of 40,000 hours.